Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to do the downgrade from 2.3.4 to 2.2.2 for CUE , becasue I need ver 2.2.2 to communicate with Call mansger ver4.0 , any reply will be vrey appreciated.
In this case,when I config CSM for load balance http and https service separately was ok.2 VIPs , 2 Serverfarms, One for http , and one for https .But I found that the https would referred to http information on IIS , because when the client first t...
I'm using CSM on ver 4.x,and I used to the bridge mode for firewall load balance,for a new requset,I have to create a new server/client vlan,but the original firewall load balance was effected when I issued the server vlan command,and I'd like to use...
Hi, I got a PIX-515 run with faiolver funtion,and I found that the PIX cpu usage was 70% ~ 80 %,I check the interface traffic around 36Mbps,and the packet forwarding rate around 62M pps,I would like to verify is this the limitation of PIX-515E.Any re...
Hi, I'm using a CSM with SSL daughter card.In this case I configure a funcion for https requesting to http server farm by CSM-s.When client initialized a https requset,the server always indicated a redirect url to client,The redirect url is http://.....
I had the same issue about guest DMZ controller , do I need to config same SSID on both of anchor and foreign controller ? I also need to use web-auth for wireless guest , which controller's SSID need to be configured web-auth ? By the way , I found ...
