With the following config I am not able to pass traffic through the LD. I can ping the virtuals from the 172.28.100 subnet but not the reals. I can ping the reals if I ping from the ld?virtual 172.28.100.36:21:0:tcp isvirtual 172.28.100.32:80:0:tcp...
Hi All,I am looking for a low end solution for Content Filtering and would like to use Cisco Content Engine.1. The documentation said that Websense, Secure Computing SmartFilter (does not require separate SmartFilter) & N2H2 support is there on the C...
Hi all,I need to redirect HTTP traffic originating from a specific range of IPs to a specific farm of HTTP servers. More specifically, I need request comming to CSS's outside VIP address on port 80/tcp to be redirected to the HTTP farm (2 boxes with ...
1.We have two CSS11503 configured to operate in a VIP & Interface redundancy mode for two VIPs. One CSS is active for one VIP and standby for the other and vice versa. Origin servers are connected through two layer 2 switches to the contenet switches...
Situation: We are using an LD-416 to load balance http and https requests for 4 web servers with publicly addressable IP's behind one publicly addressable virtual IP. Desired: We would like to setup http probes to monitor a web page on the servers an...
Hi,I have configured CE-560 for http caching by giving CFS file system of about 60Gb space. But it has been observed that every 10 days or so, this space will get filled up and hence browsing comes to a halt. I thing the content is not getting clea...
Can multiple VIP's / content rules share a single SSL module, the config guide has the following statement:The CSS supports one active SSL service for each SSL module in the CSS, one SSL service per slot. You can configure more than one SSL service f...
Hi all, let me explain my testbed:- 16 frontend proxy servers- 72 backend application servers (AS)requests to the proxy servers are first balanced from a couple of css; after that the new request originating from the proxy is balanced between the ...
We have a CSS configured as IP address 10.88.2.31, 10.88.2.56 configured as VIP.From the sniffer trace, it is sending icmp redirect to the clients accessing the VIP 10.88.2.56.Following is the message:icmp redirect ignored if=sbif2 src=10.88.2.31 dst...
Is there anyway to close SMTP and POP3 ports on a CSS11050? The services are disabled with the "restrict" command, but I wish to close the ports altogether.Version: 7.10 build 102.Thanks in advance,
Hi!Can i use this appliance to block an Internet access to a user registered in my Microsoft NT Domain? I mean block all Internet access (HTTP, HTTPS and FTP) and not just a certain group of URLs. How can o configure that?Regards,ovieira
Dear all,Apart from HTTP, could CSS 11500 SSL module offload the SSL processing of other TCP-based applications such as POP, IMAP, LDAP and SMTP ?? Thanks very muchBest regards,Joseph
We sat CSS bellow ; e0 : connected to SW(Cat4006) e2 : connected to WEB Svr #1 (w/ IP 172.31.6.41) e3 : connected to WEB Svr #2 (w/ IP 172.31.6.42) load-balancing WEB#1 and WEB#2 (w/Virtural IP 172.31.6.43) VLAN 1 : IP 172.31.6.5 (mng access IP)We al...
