Application Networking

Hi,Please advise.... i have one CSS11051, one acess router and a PIX. Where should the CSS be, in the DMZ or inside ?!?!His there any problem configuring NAT in the PIX towards the CSSWhat should be the architecture, because all the examples availabl...

hi,Ps clarify what's differences between content delviery service and network cache?difei

The CE507/560's have an "install" command for installing images from the CE's disk to the flash. The CE's are running ACNS 4.1.3(b6).Can this command be used for both the "bin" and "sysimg" files.

I am migrating applications from the LD to the CSS. One of the apps is using the LD function backup. The situation is:Currently the LD uses the backup command for some servers. In simpleterms: Web1 is backed up by Web3 Web2 is backed up by Web4In nor...

CE 570 with Software Release 2.31Our cache engines crash every 10-12 weeks. Symptoms are slow decrease of savings last 4 weeks before crash (from 48% to 34% savings bytes) and rapid increase of CPU usage last 5 days before crash.Any idea?

Regarding setting up the ArrowPoint with Virtual IP Address (group command) for the 2 HA Machines: When the 2 HA Servers try to connect to a Port on an external Server, will the return traffic know how to route to the correct HA Server ? Will it poss...

Hi there!I have the following setup and need your advise:We have tow exits to our AS only one of them is forewording traffic toword the internet at atime. both of them are connecting to each other through a small LAN that also includes a Cache-Engine...

What is the latest software version for the LocalDirector 416?I am surrently running 3.2.2.

I am facing one problem in installing Content Engine(CE)560-CDN .Problem is that if I connect the CE to the networkthen for all the network CE's IP will act as source IP.ie, Suppose if I am sending a mail sitting in thisnetwork to you the source IP (...

I have found a document on how it allow internal servers (10.x.x.x) to nat behind a registered address. But can this Address also be the same registered address that I am inbound load balancing on??

I have 2 CSS 11150 , I want to configure for fault-tolerant (Active and Standby). If one is down, another will take over.But I don’t know the way that I did it right or not. It is the first time i have worked with CSS. Any advice would much appreciat...

When you are logged on the remote CSS, is there a command where you can tell the CSS model?

We have a scenerio where it is required to load balance a Citrix Server farm.I have done the basic configuration as follows:virtual 10.172.1.73:0:0:tcp isreal 10.172.0.82:0:0:tcp isreal 10.172.0.81:0:0:tcp isbind 10.172.1.73:0:0:tcp 10.172.0.82:0:0:t...

we have got two css 11150 and wanted to add more servers to the production,how can we configure them work as one css? Thanks.

How do I find about the details of the CSS 11000 ?