cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3186
Views
0
Helpful
11
Replies

Bridge-Group Virtual Interfaces between context

blankguy7
Level 1
Level 1

Hi networker,

Actually, I'm beat me about configuring the ACE 4700!

I've read the cisco configuration guide but it is difficult to put all the configuration together! I don't find right example....

I'm trying to configure "Basic Load Balancing Using Bridged Mode on the Cisco Application Control Engine" BUT with two context, "Admin" and "Context1".

We'll find a part of my configuration, rserver and all that stuff is actually not important!

Here is my questions:

- Each context has one VLAN, both are defined in a BVI interface! How to assign this BVI Interface in a port-channel group of two interface gigabit Ethernet 1/2 and 1/3? How to assign BVI Interface in a physical interface?

- Each context has one VLAN, how to enable traffic between this VLAN between each context?

Admin context

interface gigabitEthernet 1/1

  [...]

interface gigabitEthernet 1/2

  channel-group 1

  no shutdown

interface gigabitEthernet 1/3

  channel-group 1

  no shutdown

interface gigabitEthernet 1/4

[...]

interface port-channel 1

  switchport access vlan 10

  no shutdown

access-list PERMIT_ALL line 8 extended permit ip any any

access-list PERMIT_ALL line 16 extended permit icmp any any

class-map type management match-any L4_MGMT_CLASS

  2 match protocol icmp any

  3 match protocol ssh any

  4 match protocol https any

  5 match protocol xml-https any

policy-map type management first-match L4_MGMT_MATCH

  class L4_MGMT_CLASS

    permit

interface vlan 10

  description "Client Side"

  bridge-group 1

  access-group input PERMIT_ALL

  service-policy input L4_MGMT_MATCH

  no shutdown

interface bvi 1

  ip address 192.168.10.244 255.255.255.0

  peer ip address 192.168.10.245 255.255.255.0

  no shutdown

context Context1

  allocate-interface vlan 10

  allocate-interface vlan 20

Context1 context

access-list PERMIT_ALL line 8 extended permit ip any any

access-list PERMIT_ALL line 16 extended permit icmp any any

class-map type management match-any L4_MGMT_CLASS

  2 match protocol icmp any

  3 match protocol ssh any

  4 match protocol https any

  5 match protocol xml-https any

interface vlan 20

  description "Server Side"

  bridge-group 1

  nat-pool 1 192.168.10.249 192.168.10.249 netmask 255.255.255.0 pat

  service-policy input L4_MGMT_MATCH

  no shutdown

ip route 0.0.0.0 0.0.0.0 192.168.10.1

Thanks in advance for your help and fresh idea

1 Accepted Solution

Accepted Solutions