cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

428
Views
0
Helpful
2
Replies
Beginner

Change the authentication settings of the CM

If I need to change the RADIUS or TACACS+ servers IP addresses for the CM authentication, can I just make the change in the CM GUI page? Or I should access the CM using CLI and change the device to "local authentication" before changing the RADIUS / TACACS+ details?

Thanks!

Joe

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Change the authentication settings of the CM

Hi Joe,

You should be able to do it directly from the CM. However, I would strongly recommend you to change to local authentication first in case there are any issues. If you don't, you may get locked out of your devices.

Regards

Daniel

View solution in original post

2 REPLIES 2
Cisco Employee

Change the authentication settings of the CM

Hi Joe,

You should be able to do it directly from the CM. However, I would strongly recommend you to change to local authentication first in case there are any issues. If you don't, you may get locked out of your devices.

Regards

Daniel

View solution in original post

Beginner

Change the authentication settings of the CM

Thanks Daniel for your answer!

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here
This widget could not be displayed.