cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
493
Views
0
Helpful
2
Replies
Highlighted
Beginner

Change the authentication settings of the CM

If I need to change the RADIUS or TACACS+ servers IP addresses for the CM authentication, can I just make the change in the CM GUI page? Or I should access the CM using CLI and change the device to "local authentication" before changing the RADIUS / TACACS+ details?

Thanks!

Joe

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Hi Joe,

You should be able to do it directly from the CM. However, I would strongly recommend you to change to local authentication first in case there are any issues. If you don't, you may get locked out of your devices.

Regards

Daniel

View solution in original post

2 REPLIES 2
Highlighted
Cisco Employee

Hi Joe,

You should be able to do it directly from the CM. However, I would strongly recommend you to change to local authentication first in case there are any issues. If you don't, you may get locked out of your devices.

Regards

Daniel

View solution in original post

Highlighted

Thanks Daniel for your answer!

Content for Community-Ad