CSS 11800 and upstram routers redundancy (HSRP ip problems)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-17-2002 01:21 AM
cat3512xl - c3660
ge / |
CSS Fe0/12
ge \ |
cat3512xl - 3620
in above configuration i have problem with HSRP. It doesn't works beetwen routers. When i tune SPT to made FE link as primary beetwen CATs HSRP works fine but CSS stops seeing IP addresses of routers and virtial IP...
any bode meet that ?
- Labels:
-
Application Networking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-24-2002 08:19 AM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-24-2002 11:25 PM
Oh.. i just resolved this problem myself....
the problem was in physical connections...
and some ACL misses...
now it working fine...
sorry for missup 8-)
