Inline card connectivity

[winsonfu]

Original LAN switch GE port configured 100/full and connected to router FE port (100/full) directly.

Now we are setting WAE 612 in between both devices and configured InlineGroup 1/0 to 100/full, but the router FE IP cannot be ping this moment.

When I remove 100/full settings from WAE InlineGroup 1/0, then the IP of router FE port can be ping to. But WAE InlineGroup (LAN and WAN) are showing 100/half.

Is it affected by the cable issue? Not using crossover cable to plug into Router FE port and WAE InlineGroup (WAN port).

[dstolt]

For 100/full connectivity, you need to use a crossover cable for one of your cables. Please refer to the following cabling guide for specifics.

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/wae/module/inline/installation/guide/17880fru.html#wp40063

Thanks,

Dan