Application Networking

Hello,We just started testing this brand new ACE4710 with the latest software version 1.8. It seems this box does not support URL rewrite while the ACE blade with software A2.0 does. So the question is if someone has idea URL rewrite feature will b...

We plan to loadbalance two mail servers which offer several services like http, imap and pop3. Those services are independent from each other.Our idea is to use an own serverfarm for each service, something like that :probe http http-probe...probe im...

CSS configuration with keepalive named set an IP address to the global keepalive.Into the Cisco document we can read"Configuring a Global Keepalive IP Address The CSS sends global keepalives to a service that monitors the state of services assigned t...

Is there any way to tune the http keepalives on the ACE appliance? This is how we configured our web servers to talk to our old loadbalancer.Apache config snippit:httpd.conf:KeepAlive Onhttpd.conf:MaxKeepAliveRequests 300httpd.conf:KeepAliveTimeout ...

Original LAN switch GE port configured 100/full and connected to router FE port (100/full) directly. Now we are setting WAE 612 in between both devices and configured InlineGroup 1/0 to 100/full, but the router FE IP cannot be ping this moment. When ...

ACE-gurus & Gilles , First Query: We are facing "connection failure" counter increment, what all could be the reasons for this failures and what can be done to minimize it, if its not a bug, running 3.0 A2(1.0) ?Second Query:I have a single farm wit...

the customer has installed WAAS mobile client on a notebook. When he uses IE - the http is compressed and optimized. But when he run some web application (it is based on http) over wan - the optimization doesn't work:-( Do you know where is problem??...

Hi,folksI have some questions to ask for help:We have just installed a new CSS to make VIP and Virtual Interface redundancy with the old existing one,including fate sharing function. For the topology,plz see:http://www2.picturepush.com/photo/a/716440...

hello,is it possible to configure multiple VIPs for the same virtual-router on a particular circuit configuration which uses the same redundant-interfaces instead of having to configure redundant-interfaces for each VIP that's added?I want to do some...

Hi - have just started a initial configuration on a new ACE running A2 software. I have configured a bridging SLb farm. I can connect to the VIP when the client is on the L2 bridged VLAN however cannot connect to the VIP when I am in a routed VLAN of...

i get these messages from our edge wae device, they have various host ip's not sure what to make of it. there is no routing loop unless waas/wae is doing something that i am not aware of to cause that to happen. wae is in a seperate net from the user...

Hi,In the ACE Appliance management remote access examples there is an ACL which has "permit ip any any" but in my test configurations it works fine without this. For example, icmp is controlled by whether or not there is a matching class-map entry in...

I'm trying to upgrade a WAE-512 from version 4.0.13.b.23 to 4.0.17.b.14 using http. A few minutes after pressing the submit button it appears the following message at the web:(4.0.13.b.23 [Backup of software done earlier. Backing up flash configurat...