12-03-2012 10:07 PM
Hi..
I am having WAE-7371 and WAE-574 in my network and planning to migrate my network to IPV6.. At present running IOS in my network is oe574-4.4.5c.4 at CM and oe574-4.1.1c.16 at Sites and oe7371-4.1.3a.32 at DC/DR..
Please help me out to get the IOS which support IPV6 address in WAE and WAVE device..
WAE2-DR(config)#interface GigabitEthernet 1/0
WAE2-DR(config-if)#?
autosense Interface autosense
bandwidth Interface bandwidth
cdp Cisco Discovery Protocol Interface Config commands
channel-group Configure EtherChannel group
description Interface specific description
exit Exit from this submode
full-duplex Interface fullduplex
half-duplex Interface halfduplex
ip Interface Internet Protocol Config commands
mtu Set the interface Maximum Transmission Unit (MTU)
no Negate a command or set its defaults
shutdown Shutdown the specific interface
standby Standby interface config commands
Any document presentation is much appreciated...
12-04-2012 02:43 AM
Hi Afeez,
So far WAAS does not support IPv6 at all.
I would advise you to get in touch with your account team if you want to discuss what are the current plans when it comes to implementing IPv6 on WAAS.
Regards,
Nicolas
12-06-2012 02:26 AM
Thanks Nic
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide