IPV6 support in WAE device..

[dilnaazhum]

Hi..

I am having WAE-7371 and WAE-574 in my network and planning to migrate my network to IPV6.. At present running IOS  in my network is oe574-4.4.5c.4 at CM and oe574-4.1.1c.16 at Sites and oe7371-4.1.3a.32 at DC/DR..

Please help me out to get the IOS which support IPV6 address in WAE and WAVE device..

WAE2-DR(config)#interface GigabitEthernet 1/0

WAE2-DR(config-if)#?

  autosense      Interface autosense

  bandwidth      Interface bandwidth

  cdp            Cisco Discovery Protocol Interface Config commands

  channel-group  Configure EtherChannel group

  description    Interface specific description

  exit           Exit from this submode

  full-duplex    Interface fullduplex

  half-duplex    Interface halfduplex

  ip             Interface Internet Protocol Config commands

  mtu            Set the interface Maximum Transmission Unit (MTU)

  no             Negate a command or set its defaults

  shutdown       Shutdown the specific interface

  standby        Standby interface config commands

Any document presentation is much appreciated...

[Nicolas Fournier]

Hi Afeez,

So far WAAS does not support IPv6 at all.

I would advise you to get in touch with your account team if you want to discuss what are the current plans when it comes to implementing IPv6 on WAAS.

Regards,

Nicolas

[dilnaazhum]

Thanks Nic