cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
343
Views
0
Helpful
1
Replies

Localdirector Failover with Switches

david.morrow
Level 1
Level 1

I have 2 Localdirector 430's configured for failover. I would like to eliminate an old hub which is between the LD's and the switch. When I do so, "show failover" never shows as everything working. The switch is a 2948G-L3 using BVI's on the ethernet interfaces.

1 Reply 1

seilsz
Level 4
Level 4

Are the interfaces on the client side of both LD's in the same VLAN? How about the server side? There is some good information about operating LD failover in a switched environment here:

http://www.cisco.com/en/US/products/hw/contnetw/ps1894/products_white_paper09186a0080091ed3.shtml

~Zach

Review Cisco Networking for a $25 gift card