ā05-08-2012 12:03 PM
Hello:
In an ACE module multicontext environment the buffered logging is not working on the last context I created.
The same config though works well for another context.
The maximum size and the buffer size is showing 0 in the "show logging" below:
Thanks for helping
logging enable
logging standby
logging timestamp
logging trap 5
logging history 4
logging buffered 5
logging facility 16
logging queue 200
logging device-id context-name
logging host 10.10.10.1 udp/514
logging host 10.10.10.2 udp/514
logging rate-limit 42 60 level 0
logging rate-limit 42 60 level 1
logging rate-limit 42 60 level 2
logging rate-limit 42 60 level 3
logging rate-limit 42 60 level 4
logging rate-limit 42 60 level 5
logging rate-limit 42 60 level 6
logging rate-limit 42 60 level 7
##################################################
show logging`
Syslog logging: enabled
Facility: 16
History logging: enabled (level- warnings)
Supervisor logging: disabled
Trap logging: enabled (level - notifications)
Timestamp logging: enabled
Fastpath logging: disabled
Persist logging: disabled
Standby logging: enabled
Rate-limit logging: (min - 10000 max 100000 msgs/sec)
42 messages 60 seconds level 0
42 messages 60 seconds level 1
42 messages 60 seconds level 2
42 messages 60 seconds level 3
42 messages 60 seconds level 4
42 messages 60 seconds level 5
42 messages 60 seconds level 6
42 messages 60 seconds level 7
Console logging: disabled
Monitor logging: disabled
Logging to 10.10.10.1 udp/514
Logging to 10.10.10.2 udp/514
Device ID: context name "CTC_PROD7"
Message logging: none
Buffered logging: enabled (level - notifications) maximum size 0--------------------------->>>>>>
Buffer info: current size - 0 global pool - 4194304 used pool - 4194304
min - 418816 max - 0
cur ptr = 0 wrapped - yes
Solved! Go to Solution.
ā05-08-2012 01:19 PM
Hi,
This is because your global pool is full. Go to one of your other contexts clear logg , and will work.
Buffer info: current size - 0 global pool - 4194304 used pool - 4194304
Dan
ā05-08-2012 01:19 PM
Hi,
This is because your global pool is full. Go to one of your other contexts clear logg , and will work.
Buffer info: current size - 0 global pool - 4194304 used pool - 4194304
Dan
ā05-09-2012 06:21 AM
Thank you. I will try that.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide