Application Networking

Topologywaas mobile client ---------waas appliance---------wan---------waas appliance---------waas mobile server---------------applications/serversWhat will happen in this topology?  Who is going to perform the acceleration function?Can waas mobile c...

Hi,We deployed a WAAS 694 lately and have the following issue.The version used is : 4.4.5This appliance has 2 PSU working just fine (we tested it), but we have the following alarm (show alarm detail) : Critical Alarms:                                ...

Hi,I am having a Cisco ACE 4710 (c4710ace-mz.A3_2_0.bin).I have two SMTP Servers that are load balanced with VIP Address. It is a single arm configuration. (Predictor = Round Robin)My issue is that, client is complaining that ACE is not doing a prope...

Hi,We have cisco ace 30 modules installed in cisco 6500 switches. For application availability purpose from the internet, we need to have some global site selector/3rd party devices with similar feature set that of cisco gss.My question is: whether c...

Hi,Our ACE configuration includes some services where the ACE is providing SSL offloading and also some other service where the ACE is loadbalancing of client SSL traffic going to back end Apache servers that terminate the SSL. I am trying to create ...

My ACE is almost completely configured - with VIPs, farms, real servers, redirects etc. Port 80 and 443 are working as expected and web requests are getting routed appropriately. The need has arisen however, to allow a non-traditional port to be allo...

I have seen so many users reporting this issue on the Cisco Support Community and yet noone  has posted any resolution or followup.I am having the same issue and has to backout the cutover.I see in the traces that the ACE is initiating RST.Any soluti...

Am trying to replicate the managment interface functionality of a CSS on ACE 4710 but have problem with it being treated as a general routed interface.ScenarioOn ACE 4710 I have a front-end interface for client facing VIPS and a back-end interface fa...

Hi ,I tried to change my main switch devices few month ago, but I couldn't. because the new devices not support to the WAAS.Recently, CISCO has released new S/W for the new device to support WAAS. The new S/W only support the WCCP version 2.If we...

  WCCP router 10.10.177.133 unusable for service id: 61 reason: Assignment method mismatch with router   WCCP router 10.10.177.133 unusable for service id: 62 reason: Assignment method mismatch with router   10.10.177.133 is the loopback of the route...

Hi All,I have recently configured a pair of ACE 4710 appliances in a FT group. The ACE's are deployed in one-arm mode, using Source NAT, with all routing to and from being done by a pair of PIX firewalls.My configuration does not include the use of a...

My WAAS deployment is currently at 4.4.5 and I just got a hold of 4.5.1 through my account manager. Not sure if I can do a direct upgrade or not since the release notes for 4.5.1 states the following:Upgrading to Version 4.5.1 is supported only from ...

We are currently running ANM server version 4.1.  I am trying to upgrade to version 5.1.  But when I run the "application upgrade anm-va-5.1.ova Upgrade" command, I receive an error that states:  "Manifest file not found in the bundle" I then tried t...

                   Hello All,I have the scenario below and the comunication between the Routers and Core Switchs are in a load share way witch means that we will have asymmetry on the WAAS below. How can we avoid it ? is there any specific configurat...