06-20-2007 02:43 AM
We need to know about MIMIX port at IBM AS/400, we are now doing POC using Cisco WAE, here is the topology :
DC--> Cat6513 <------>Cat6513 <---DRC
| |
Cisco WAE Cisco WAE
our cisco WAE can not capture traffic from MIMIX IBM AS/400.
please we need advice for this case.
Regards
06-22-2007 09:46 PM
Afdllah,
Are you using Cisco WAAS? If so, can you please provide some additional information on how you are performing interception?
Thanks,
Zach
07-01-2007 08:24 PM
Yes, I used Cisco WAAS version 4.0.9,
i configure WCCP on both switch catalyst on interface vlan :
ip wccp 61
ip wccp 62
int vlan888
ip wccp 61 redirect out
ip wccp 62 redirect in
on interface to WAE ;
ip wccp redirect exclude in
regards
afdil
07-11-2007 08:36 PM
Zach,
Have you ever try WAAS to accelerate MIMIX traffic? Could you share your configuration?
Thanks,
Iwan
07-12-2007 06:33 AM
Iwan,
I have not personally used WAAS to accelerate MIMIX traffic.
Thanks,
Zach
07-13-2007 12:15 AM
Hi Zach,
But, do you have any documentation that mention WAAS able to accelerate MIMIX traffic or user guide about it? Because I cannot find it on cisco website and I am afraid that Cisco WAAS is unable to accelerate MIMIX.
Thanks,
Iwan
07-13-2007 08:59 PM
Ivan,
I checked internally, but was unable to find any references for WAAS optimizing MIMIX traffic. However, this doesn't mean that it isn't possible. Have you tried? Do you know the TCP ports being used?
Zach
07-15-2007 10:43 PM
Zach,
I have tried it with several scenario. First, using default WAAS policy. Second, create new policy using destination and source port from 1000-65000. Both scenario give no result. I have no idea the exact TCP port for MIMIX.
Iwan
07-16-2007 07:33 PM
zach,
when i'm doing POC to optimize MIMIX,
i use command :
#show tfo connection summary
and output of this command :
Local-IP:Port Remote-IP:Port Conn Type
10.204.230.2:50007 10.204.229.2:56028 PT In Progress
10.204.229.2:56028 10.254.20.11:50007 PT In Progress
ip add 10.204.230.2 is MIMIX server in DC
ip add 10.204.229.2 is MIMIX server in DRC
i already used that port to optimize MIMIX,
but still not optimize
07-18-2007 07:17 AM
AFDILAH,
You can use the debug command:
debug tfo conn auto
to determine why the connection is going into pass-through.
Zach
07-19-2007 11:12 PM
Thank Zach, we will try it. But unfortunately, we cannot do it soon. We need time to setup the lab.
Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide