07-24-2010 01:54 AM
Hi,
I am trying to configure proble on ACE device and I have few queries on those:
1. I want to probe 10 different tcp ports for a serverfarm, is there any way i can give the range on probe ? if not and if i have to probe individual port and then configure in a serverfarm, how it would behave i.e. I want to fail the probe only when all the configured ports are failed.
2. I am trying to configure probe for a particular tcp port, but I suppose server is not sending RST to that port, so probe is failing. However if I try to telnet that port from any other location it is getting connected. How can I configure probe in that case for that port ?
Pls. suggest.
Thanks
Pawan
07-25-2010 08:18 AM
You will need to configure a probe for each port.
Add all the probes to the serverfarm.
Use the command "fail-on-all" under the serverfarm.
Gilles.
07-26-2010 12:25 AM
Thanks Gilles, Could you pls. suggest on my 2nd query too ?
2. I am trying to configure probe for a particular tcp port, but I suppose server is not sending RST to that port, so probe is failing. However if I try to telnet that port from any other location it is getting connected. How can I configure probe in that case for that port ?
Thanks.
07-26-2010 02:24 AM
You should sniff the traffic ...if the probe is down it means the server did not respond to our SYN.
We do not expect a RST.
Gilles.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide