01-18-2012 06:09 AM
How do I set the virtual blade to autostart. After MS updates we did a reboot, and the server did not come back up until I went into the Central Manager and selected "Start Virtual Blade". Is there a setting in there to make sure the blade is set to autostart?
Solved! Go to Solution.
01-18-2012 06:16 AM
Hi,
Can you check and see if Auto Start is checked for this Virtual
blade configuration and it is set to boot from disk rather cdrom? See below
link
http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v411/configurati
on/guide/virtual.html#wp1051532
Ahsan
01-18-2012 06:16 AM
Hi,
Can you check and see if Auto Start is checked for this Virtual
blade configuration and it is set to boot from disk rather cdrom? See below
link
http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v411/configurati
on/guide/virtual.html#wp1051532
Ahsan
01-18-2012 07:27 AM
Yes, it is checked now. Thank you! I knew it was right under my nose.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide