Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

Resolved! kernel_crash

Hi thereI'm having some issues on WAAS devices with Kernel_crash 's. How can this be resolved?sabf-0051-kuruman-wae-1#sh alarmCritical Alarms:----------------NoneMajor Alarms:-------------        Alarm ID                 Module/Submodule             ...

Does anyone have an idea what the cause of these error messages would be? I searched CCO to see if I could locate what they are and mean (technical definition). I was only able to locate that they could be an output (you don't say).Aug 31 2011 18:28:...

Joe Dunn by Community Member
  • 3017 Views
  • 7 replies
  • 0 Helpful votes

Hi AllThe CIFS service on a NME-WAE-502 is showing an "disabled" operational state however the Config State is "enabled" and reporting a "cifs_ao_down" alarm. I've tried re-enabling the accelerated service via the CLI and the console reports that it ...

da.newman by Level 1
  • 5333 Views
  • 7 replies
  • 0 Helpful votes

Hi my name is IvanI have a wae 674 totally new. I did the upgrade of memory from 2 to 4 GB, putting the couple of memory in slots 7 and 10. When I power on the wae, I observe the follow mistake Broadcom UNDI PXE v2.85Copyright (C)  2000x2006 Broadcom...

Hopefully this is an easy question but I am having a heck of a time finding an answer.We have multiple CSS 11500 clusters.  We have found that on all of them, if you try to open a session on any port to an IP address on the backend of the CSS, the CS...

Hello,I am trying to configure a basic access list on a branch WAE. I wish to only accelerate traffic going to net 10.10.10.0/24. When I enter this command however it blocks all inbound traffic as well. Am I doing something very stupid ? Also, There ...

Top Solution Authors

Review Cisco Networking for a $25 gift card