Virtual Blade Not set to Autostart

[Dan Loring]

How do I set the virtual blade to autostart.  After MS updates we did a reboot, and the server did not come back up until I went into the Central Manager and selected "Start Virtual Blade".  Is there a setting in there to make sure the blade is set to autostart?

[ahskhan · Accepted solution]

Hi,

Can you check and see if Auto Start is checked for this Virtual

blade configuration and it is set to boot from disk rather cdrom? See below

link

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v411/configurati

on/guide/virtual.html#wp1051532

Ahsan

[Dan Loring]

Yes, it is checked now. Thank you!  I knew it was right under my nose.