So i setup an etherchannel with my WAAS and while im not
experiencing any issues...im seeing something a little odd
WAE
!
primary-interface PortChannel 1
!
interface PortChannel 1
ip address x.x.x.x x.x.x.x
exit
!
!
interface GigabitEthernet 1/0
channel-group 1
exit
interface GigabitEthernet 2/0
channel-group 1
exit
!
Switch
!
interface Port-channel5
description WAAS Port-Channel
switchport access vlan 5
load-interval 30
end
interface GigabitEthernet1/0/18
description WAE-0423-574
switchport access vlan 5
channel-group 5 mode on
spanning-tree portfast
end
!
interface GigabitEthernet2/0/12
description WAE-0423-574
switchport access vlan 5
channel-group 5 mode on
spanning-tree portfast
end
but when i do a show po5 this is what i get
sh int po5
Port-channel5 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 0022.bd3f.1d12 (bia 0022.bd3f.1d12)
Description: WAAS Port-Channel
MTU 1500 bytes, BW 2000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 0/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
Members in this channel: Gi1/0/18 Gi2/0/12
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters 23:03:19
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
14696018 packets input, 9052608888 bytes, 0 no buffer
Received 6310 broadcasts (2766 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 2766 multicast, 0 pause input
0 input packets with dribble condition detected
12948000 packets output, 5120404982 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
