Application Networking

currently we have access lists that allow any traffic to the interfaceshowever a new design has come up about setting up a new VIP and only allowing 6 hosts to that VIPwe still want to keep the any any on the interface-butwould I do this using class ...

Hello Guys,Customer is looking to load balance Dot1x traffic going to many Cisco ACS servers. Concern is ACS server do not maintain any states so need to make sure that all the requests from a particular ip going to multple ports(1812 and 1813) are g...

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in ...

Hi all,I did a "ft switchover all" on the primary unit in order to reboot it afterwards, and I get the above message.Group ID 2 does not switch over.All contexts in the primary are active and in the secondary standby_hot before I attempt the switchov...

Hi,I have the following questions about the VIP locations.From the configurations guides, you configure a VLAN X  for clients (where the traffic to be balanced arrives), and VLAN Y for  servers (where the real servers are) - for router mode these are...

HiI have restarted the WAE and now I've this message:The device_mgr service has been disabled. here is message from CLI:ASERVER-53#sh alarmsCritical Alarms:----------------     Alarm ID             Module/Submodule     Instance     ------------------...

Hi,Does any one have an experience to configure cisco WAAS on vmware machine. if yes then kindly share the procedure with me, i really appreciated...Since i have configured cisco NAC, MARS and IPS on vmware so I believe this will be the possibility t...

I ran into a problem last year when running WAAS WCCP and IOS firewall IP inspection on the same 3945 router. They couldn't function at the same time. Cisco indicated that router IOS firewall and WCCP were compatible only when IOS zone-based policy c...

Hi all,Quick question. If you have a CSS 11503 with one SSL offload module installed.. is there any point in using the "application ssl" and "advanced-balance ssl" options in the content rule? I can't find any info that tells me for sure but I'm gues...

Hi,I setup an ace module in bridge mode as follows:mfsc(vla80) > (vla80)outside fwsm, fwsm inside(vla40) > (vla40)ace-clientside, aceserverside(vla41)and the servers have the fwsm svi(vla40) as their gateway. But, the ace is not loadbalancing.The con...

I have a problem with ACE (system A2(1.1)) and Internet Explorer 8.exactly:ACE is configured as end-to-end ssl with 2 rserver and with the sticky source address. When user is opening the virtual address from IEv7, the web portal (On Microsoft IIS) wo...

Hi,I have a question about CSM, possibly might be security related not sure.I have a CSM in routed mode with a Client VLAN and a Server VLAN.Now the Server Guys would like the Server's in the farm to be able to initaite connections outbound to anywhe...

I have a question relating to a CSS and Exchange Mobile devices The customer has 2 Exchange Client Access Servers CAS1 and CAS2 and has problems with ActiveSync on mobile devices. (OWA is working fine) I am trying to test Exchange ActiveSync (using t...