cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3335
Views
0
Helpful
3
Replies

WAAS Inline Card Issue

adrien.dupont
Level 1
Level 1

Hello Everyone,

I have a question about Cisco WAAS (Wide Area Application Services).

We want to use the new WAVE-294, WAVE-594 and WAVE-694 in Inline mode (no wccp) We have several WAVE with WAVE-INLN-GE-4T included (by Cisco) in order to use the InlineGroup.

We have a problem with WAVE with no Inline card included. When we insert the card after the first boot, we have 4 GigabitEthernet port UP but no InlineGroup 1/0 and InlineGroup 1/1.

This is a correct configuration :

interface InlineGroup 1/0
 inline vlan all
 no autosense
 bandwidth 100
 full-duplex
 exit
!
interface InlineGroup 1/1
 inline vlan all
 no autosense
 bandwidth 100
 full-duplex
 exit
!

This is an incorrect configuration :

interface GigabitEthernet 1/0
 shutdown
 exit
!
interface GigabitEthernet 1/1
 shutdown
 exit
!
interface GigabitEthernet 1/2
 shutdown
 exit
!
interface GigabitEthernet 1/3
 shutdown
 exit
!

WAVE doesn't want to "create" the inlineGroup even if we reboot the device or write erase the configuration without the setup configuration.

The only way to configure the Inline Group is to

1 - remove the InlineCard

2 - write erase the startup-configuration

3 - boot the device

4 - use the Setup Wizard

5 - configure the rest of the configuration after the boot

Is it possible to avoid the long process ? I don't find a command to create these inlineGroup.

Thank you for your sollicitation

Regards

Adrien Dupont
1 Accepted Solution

Accepted Solutions

Hi Adrien,

As per the installation guide : http://www.cisco.com/c/en/us/td/docs/app_ntwk_services/waas/wave/installation/594-694/guide/WAVE-594_HIG/594op2.html#91439

interface modules are not hot-swappable !

Best Regards

Finn

View solution in original post

3 Replies 3

adrien.dupont
Level 1
Level 1

Hello,

We tried again in this order :

1 - write erase without the card included

2 - shutdown the device

3 - insert the Inline-Card

4 - Boot the device

5 - Enter the commande "interception-method inline"

 And that's all. i think we have the problem when we hot-insert the card.

It's ok for us !

Regards

Adrien Dupont

Hi Adrien,

As per the installation guide : http://www.cisco.com/c/en/us/td/docs/app_ntwk_services/waas/wave/installation/594-694/guide/WAVE-594_HIG/594op2.html#91439

interface modules are not hot-swappable !

Best Regards

Finn

I'm unable to resolv this issue with those option. I just type: "inline enable" command and works! =)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: