Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts,
I have an issue with our Cisco WAAS and the MAPI protocol. There is our scenario :
- 1 WACM : WAVE-294-K9, version 5.5.3.b59
- 2 WAAS on the DC : WAVE-694-K9, version 5.5.3.b59
- X WAAS on remote site : WAVE-294-K9, version 5.5.3.b59...
Hi everyone,
I have an issue with our WAAS. We use the version 5.5.3.59 on OE694 and OE294 and accelerator cifs is enable.
When we create a preposition file in Home > Configure > CIFS File Services > Preposition and we use a location in FileServer S...
Hello everyone,
I try to configure a kind of Fallback RADIUS, I explain :
Il want two radius server in my WLAN :
- In one RADIUS, we have serveral users (first AD)
- In the other one, we have the rest of our users (second AD)
Is it possible to swit...
Hello Everyone,
I have a question about Cisco WAAS (Wide Area Application Services).
We want to use the new WAVE-294, WAVE-594 and WAVE-694 in Inline mode (no wccp) We have several WAVE with WAVE-INLN-GE-4T included (by Cisco) in order to use the In...
Hello Finn,Thank you for your reply. We found that we have the preposition configuration at the end of the remote WAAS. It's possible to add a preposition statement in CLI but it can be visible in the GUI. The opposite is not true. Yes, we tried with...
Hi,
So it's not possible on Cisco WLC. I just want to compare with a another manufacturer, we have this option :
fail-over: Fail-over is always enabled. Fail-over means is that if the first auth-server is not reachable (time-out), the second server...
Hello,
We tried again in this order :
1 - write erase without the card included
2 - shutdown the device
3 - insert the Inline-Card
4 - Boot the device
5 - Enter the commande "interception-method inline"
And that's all. i think we have the problem wh...
Hello,
There is a Cisco bug : CSCuz64174 / PI 3.x - Missing links in topology with latest DP 4/5.
Symptom:links between devices are randomly missing.Conditions:The DP will cause links to be not detected for devices discovered AFTER applying DP4 or ...
Hello,We have the same problem with our CPI 3.0.0.0.78.
We added the switch with SSH and SNMPv2 credentials and when we go to the Network Topology, we only see the switch and no links.When we click to the 360view, we can see that "only" Local Remote ...
