I have recently moved my WCCP redirection at my remote locations from my 3750 switch stack to the WAN routers. I have noticed strange statistics when issuing the "show interface" command. Please take a look at the output below.
bos14rtrwn01#show int mult 1
Multilink1 is up, line protocol is up
Hardware is multilink group interface
Description:
Internet address is x.x.x.x/30
MTU 1500 bytes, BW 3072 Kbit, DLY 100000 usec,
reliability 255/255, txload 10/255, rxload 239/255
Encapsulation PPP, LCP Open, multilink Open
Listen: CDPCP
Open: IPCP, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 2 seconds on reset
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters 24w6d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 2179006
Queueing strategy: Class-based queueing
Output queue: 0/1000/64/2179006 (size/max total/threshold/drops)
Conversations 0/249/256 (active/max active/max total)
Reserved Conversations 3/3 (allocated/max allocated)
Available Bandwidth 1414 kilobits/sec
30 second input rate 6518000 bits/sec, 665 packets/sec
30 second output rate 121000 bits/sec, 105 packets/sec
1262906121 packets input, 1638232792 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
6 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
1022086252 packets output, 925409604 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
bos14rtrwn01#show ver
Cisco IOS Software, 3800 Software (C3825-ADVIPSERVICESK9-M), Version 12.4(15)T3, RELEASE SOFTWARE (fc1)
Obviously this is a 3Mb circuit but my input rate indicates 6.5Mb. Something is off here. I have checked the Bug toolkit but did not find anything.
Anyone else having this issue?
