Application Networking

How upgrade ACNS to WAAS?thank you

Hi Friend,I am facing UDP flows problem.When I enable flow-enable for DNS server use command "flow-state 53 udp flow-enable", after 2-3 hours the DNS service was not work well.Can not resolve some record from DNS server intermittently.CSS11501(debug)...

please see my CSS configure, it is a basic config, but CSS always divert the traffic to 10.122.70.13, even it is down, while 10.122.70.14 untouched:!************************* INTERFACE *************************interface 1/1 trunk vlan 25 vlan 70inter...

Hello, I have been reading the Ace configuration manual and other resources but cannot find clear answers. I would like to clarify the Ace behaviour for the following please (or recommended reading):Q. How does the Ace handle connection establishment...

Hi All,I have a situation with my central manager. I have a project for about 200 branches and they purchased just one central manager. The problem now is that the central manager is corrupted. I cant configure it or even recover it because once i ty...

Hello there, I hope that you can help me. I have a case with the TAC trying to solve this isssue, this is my topology:+---------+ +---+| ACE01 | | - |+---------+ -------- | - | SERVER 01+---------+ -+ +---- | - || 6500-01 | | | | |+---------+ | | +--...

I wonder if someone can tell me if the Cisco ACE 4710 Apppliance supports the following functions:1. IPv62. routing protocol such as OSPF, BGP or RIP3. Policy based routing or source routing

Hi All,I am not able to connect to a virtual IP address of ACE 4710 and either i am able to ping it. Kindly let me know if anything wrong here.Regards,Neha.

Hi All,We have 2 content switches(CSS11509-K9) and i want to impement VRRP.Both of the switches are getting Master when i configure it.It was working fine previously on another location i removed it and connected in my company and here is the problem...

Hi,I want to know the correct procedure for replacing the faulty CSS with the new CSS 11501 switch. Currently the backup css is master and i have the new css in front of me, so now if i configure the new CSS and connects the cable back from the fault...

I created a VIP on our ACE 4710 and assigned it a URL in DNS. On my machine I can access the newly created website with no problems.I sent the URL out to 6 other people so that they could test and none of them can access the site. They can access the...

Hello all. Is it possible to convert previously bridge Fast Ethernet interface on the 11501 CSS to be trunk interface? I have run of out of interfaces to bridge VLAN's so I want to trunk them to the CSS.The 6509 core switch is the L2 switch that brid...

I am trying to configure tacacs on a WAAS device using 4.1.1c. I have configured the tacacs server to allow the user to login using privilege level 7 then the user is required to enable the device and login again to reach privilege level 15. When eve...