Cisco Data Center Overlays with focus on VXLAN (Virtual Extensible Local Area Network) (Live Webcast October 20th, 2015 at 10:00 am Pacific Time / 1:00 pm Eastern Time)
During this live event, Cisco subject matter expert Vishal Mehta shares about Cisco Data Center Overlays with focus on VXLAN (Virtual Extensible Local Area Network). In the modern data center, traditional technologies are limiting the speed, flexibility, scalability, and manageability of application deployments. There is emerging interest in the industry in overlay technologies (such as MPLS, VXLAN, LISP...) which may address some of these challenges. This session will discuss the latest trend in Overlay Technologies and compare each one of the available solutions in terms of deployment, benefits and challenges. The major emphasis in this session will be on VXLAN evolution and to elaborate on which Cisco Products support different VXLAN solutions. Various VXLAN configurations such as BGP-EVPN control plane, L2 Gateway, L3 Gateway; Bridging, Packet-Flow, Best Practices, Deployment scenarios and other advanced features will be also discussed.
Vishal Mehta (Read the Interview) is a Technical Marketing Engineer with Cisco's Data Center Competitive Insights Team based in San Jose, California. Previously he was working as the customer support engineer for Data Center Server Virtualization Technical Assistance Center (TAC) team for the past 4 years with a primary focus on data center technologies such as Cisco Nexus® 5000, Cisco UCS, Cisco Nexus 1000V, and Virtualization. He has CCIE® certification (# 37139) in Routing/Switching, Service Provider & Data Center. Vishal has presented at Cisco Live in Orlando 2013, Milan 2014, and San Francisco 2014 (BRKCOM-3003, BRKDCT-3444, and LABDCT-2333).
hello, i tried to find a document describing it but was not successful. i understood that on an ACI witch a BD and one EPG is always consuming an internal VLAN. maximum numbr of vlans is 3964 (or similar). therfore you can approx copnfigure 1980 EPGs...
Hi, For a UCS customer can I use 93360 and provide both IP and SAN networking in a converged infrastructure deploymentBasically UCS+FI is connecting to 93360 (instead of 93180+MDS) for internet and SAN array Thanks & Regards,Sreeram
Hi community, I have a case where we have a typical MultiPod deployment (2 Spines connecting to 2 IPN devices at each site, 2 IPN devices connecting to each other and connecting to the other sites via P2P). The dedicated IPN is configured to support ...
Hello all, We recently had an issue where an endpoint was flapping between 2 different tunnels (TEP's) on an ACI leaf, i.e. the leaf was learning about the endpoint from 2 other leafs at the same time, causing the next hop leaf to constantly change t...
Hi,I have the following questions can we run a HA link of firewall(Fortinet, Palo) over ACI multipod. Do we need to take any special considerations into account recording the ACI endpoint learning beheaviour? Frederik