This topic is a chance to discuss more about the implementation and troubleshooting of Virtual Switching system (VSS) on Cisco Catalyst Switches, particularly on 4500, 6500 and 6800 Virtual Switching System (VSS) is network system virtualization technology that pools multiple Cisco Catalyst 6500 Series Switches into one virtual switch, increasing operational efficiency, boosting nonstop communications, and scaling system bandwidth capacity to 1.4 Tbps. At the initial phase, a VSS will allow two physical Cisco Catalyst 6500 Series Switches to operate as a single logical virtual switch called a virtual switching system 144.
This session provides an opportunity to learn and ask questions about how to implement, configure and troubleshoot VSS in Cisco Catalyst Switches.
Ask questions from Monday 11th to Friday 29th of June, 2018
InayathUlla Sharieffis a Customer support engineer in High-Touch Technical Services (HTTS) team supporting LAN Switching and Data centre Products. His areas of expertise include Cisco Catalyst 2000,3000,4000 ,6500 and Cisco Nexus 7000 Switches. Shariff has over 10 years of industry experience working with large enterprise and Service Provider networks. He holds a Bachelor’s Degree in Computer Sciences and the following Cisco certifications: CCNA, CCNP (in Routing and Switching), and CCIE in R&S (# 43263).
Atul Choudharyis a Customer Support Engineer in High-Touch Technical Services (HTTS) at Cisco Bangalore, India. He has over 5.5 years of industry experience working with large Enterprise, Security and load balancers. He has been working with HTTS from past 2 years and supporting LAN Switching Products. His areas of expertise include Cisco Catalyst 2000, 3000, 4000, 6000, and 9000 Catalyst Switches. Atul holds a Bachelor's Degree of Sciences in Electrical and Electronics Engineering from Maharshi Dayanand University and he is pursuing a Masters of Technology in Software Systems from BITS, Pilani. He hold several certifications such as, JNCIA-Junos, JNCIS-ENT, JNCIP-ENT and he is pursuing a CCIE R&S.
InayathUlla and Atul might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Contact Center Community
i have an issue like that, actually the port i have connect to mikrotik crs, then log says like that.the port still up down right now.what should i do? config : interface GigabitEthernet47description SW-LANTAI3spanning-tree portfastspanning-tree...
Hi Guyswhen running hsrp between 2 data centres across a lan link, what are people doing these days, in the design guide when running OTV etc it says you should block the hsrp multicast traffic effectively creating anycast gateways on each site.What if yo...
Hi, In the AP stats capture menu it is possible to enable AP stats capture globally for all AP's.According to: https://www.cisco.com/c/en/us/products/collateral/cloud-systems-management/dna-center/guide-c07-744044.html"Cisco DNA Center can suppo...
CISCO 1921 CAN BE USED WITH No.2 HWIC-4ESW? or just one expansion slot can have ethernet connection? I require both expansion slots to be 4 ethernet 10/100 ports but i'm not sure if with 1921 is possibe.Thank you
Hi all I have been trying to license the C93180YC-FX running 9.3.7 for the entire morning and I cannot make it to register to the on-Prem SSM. I am very familiar with IOS-XE smart licensing but Nexus seems to be a different beast. I have an...