cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please note that Remote Expert Mobile announced end-of-life and support will end on February 28, 2022.
431
Views
0
Helpful
2
Replies
Beginner

CiscoIPPhoneExecute - NavDown and VolDown are not accepted

I am trying to send key presses to remote phones using the CiscoIPPhoneExecute POST method. My code works perfectly, I can send all commands except NavDown.

I can successfully send NavUp key press:

<?xml version="1.0" encoding="utf-8"?>
<CiscoIPPhoneResponse>
<ResponseItem URL="Key:NavUp" Data="Success" Status="0" />
</CiscoIPPhoneResponse>

NavDown key press produces an error:

<?xml version="1.0" encoding="utf-8"?>
<CiscoIPPhoneResponse>
<ResponseItem URL="Key:NavDown" Data="URI not found" Status="6" />
</CiscoIPPhoneResponse>

 

Looking at the XML schema file in the phone application development notes, NavDown is a supported key. Tested on both 79xx and 88xx phones, including the latest firmware version.

Same issue for VolUp (works fine) and VolDown (throws an error)

I can only assume that there is a bug in the code.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CiscoIPPhoneExecute - NavDown and VolDown are not accepted

Looking at the latest dev notes, it looks like those keys are 'VolDwn' and 'NavDwn' (note the lack of an extraneous 'o')...can you check?

2 REPLIES 2
Cisco Employee

Re: CiscoIPPhoneExecute - NavDown and VolDown are not accepted

Looking at the latest dev notes, it looks like those keys are 'VolDwn' and 'NavDwn' (note the lack of an extraneous 'o')...can you check?

Highlighted
Beginner

Re: CiscoIPPhoneExecute - NavDown and VolDown are not accepted

You are right. These are the correct keys. I was looking in the wrong section of the documentation (under XML schema), I see now there is a Device Control URIs section that has the correct information.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards