C2960X - %SNMP-3-INPUT_QFULL_ERR - Bug: CSCuz93302

[Mozambique]

Hello,

We wound the following bug on our stack of C2960Xs: https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuz93302

The logging is full of %SNMP-3-INPUT_QFULL_ERR errors, tried to restart the SNMP engine several times, but the bug comes back after a few hours. In the bug report I see that we would need to engage TAC to find the OID that is causing this problem. However since this device is only covered under warranty, it is not possible to open a TAC case.

Is there a way to find it without a TAC, or anyone has an idea which OID it might be?

Software version:

(C2960X-HBOOT-M) Version 15.2(6r)E, RELEASE SOFTWARE (fc1)

Thank you.

[Kasun Bandara]

why dont you upgrade the OS to fixed release

[balaji.bandi]

I believe cisco should support software :

https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-x-series-switches/qa_c67-728348.html

as a suggested upgrade or you can contact TAC (if you are the owner of the switch).

[Mozambique]

Thanks for the answer, I can't open a TAC case as this device is only covered under warranty   // RMA

[balaji.bandi]

Nothing much we can do as community, Either upgrade to suggested version, or diable as suggested SNMP.