CSCux99279 - rv130w Fail to Delete IPv4 ARP entry - 1

[pauloneto1964]

rv130w Fail to Delete IPv4 ARP entry ??? this give with firmware version 1.0.14 to fix this problem please....

[hakon]

I have RV130 (PID VID: RV130 V01) running  version 1.0.3.16 and on two days I have 998 emergensy entries for "Fail to delete IPv4 ARP entry".

[andrewoo17]

I have an RV130 model with firmware version 1.0.3.14 and the log have been flooded with "Fail to delete IPv4 ARP entry" ....

So I believe the problem is not with the wireless model only.

Really hope Cisco will look into it soon.

[patric]

Hello!

I have an RV130 model too and someone know if there is a hotfix to this problem?

regards

[kevinwalkerca99]

I have seen this same issue on my RV130 (non wireless) since 1.0.2.7.  It was still there in 1.0.3.14, 1.0.3.16, and still happens in 1.0.3.22.

[pauloneto1964]

RV130W Wireless-N VPN Firewall

Firmware Version:	1.0.3.16
Serial Number:	CCQ19182X2X

PID VID:

RV130W-E V01

(Fail to Delete IPv4 ARP entry ???) with the last and new firmware version 1.0.3.16 

whow to fix this problem please....????

[reymondier.anthony]

on RV130 VPN (no wifi) v1.0.3.27 same log message.
Is it critical ?

[hakon]

If I look into the logfile, it is not only critical it is an emergensy ;-)
Are you asking if this is something that I would pay a Cisco Consultant to fix, I would say no.

But users might look away from using Cisco's small routers, because Cisco do not seem to keep up further devolopment on them.

[reymondier.anthony]

Thank you for your reply.
It is nice to know that someone who had the issue is still following.

My RV130 in v1.0.2.7 is without wireless so I don't know to "disable wireless" as suggested by the "BugSearch" solution.
Since I am using it for DHCP and that once a PC is detected I put its IP as StaticDHCP, maybe the log message is just a "warning".

I will have to test tonight.