CSCvk71052 - ACI 9500 PSU doesnt power on after low voltage/blip condition

[spbench]

Will Cisco provide a fix for this bug in an upcoming firmware release to avoid having to unplug and re-plug the power cords on the 9508 spines and leafs?  If yes, does Cisco have any approximate time when the fix will be made available?

Nick Venidis

[Daniele Giordano]

Hi, i see in the bug toolkit that the status of this bug is fixed. Below some informations:

Issue applies to any PSU FW under 4.01.
#"show hardware internal version" to view the version the PSU is using.

a-spine1# show hardware internal version
-------------------------------------------------
Name InstanceNum Version
-------------------------------------------------
PowerSupplyFMW 1 P:4.00,S:4.00
PowerSupplyFMW 2 P:4.00,S:4.00
PowerSupplyFMW 3 P:4.00,S:4.00
PowerSupplyFMW 4 P:4.00,S:4.00

Check the firmware of your power supply.

Known Affected Releases:

13.1(2m)

Upgrade the system software ACI to a fresh release.

Regards.