01-25-2019 04:05 AM - edited 01-25-2019 05:02 AM
I am trying to initiate "traceroute" command on Cisco ASR 9010 and 9912, but it failed to initiate and show no results.
In fact, IOS-XR stuck with initiating the command.
Platform: ASR 9010 , ASR 9912
IOS-XR Version: 6.2.3 , 6.4.2
Please find the attached file.
Note: sometimes works correctly (most of the time not working correctly).
02-22-2019 06:48 AM
Hello,
from below I'd say it depends on more factors than visible in this post.
Kind Regards,
Andreas
RP/0/RSP0/CPU0:ASR9K-2#traceroute 192.168.224.80 source lo0
Fri Feb 22 15:46:53.836 CET
Type escape sequence to abort.
Tracing the route to 192.168.224.80
1 *
10.10.10.65 3 msec
10.10.10.61 0 msec
RP/0/RSP0/CPU0:ASR9K-2#sh ver brie | i Cisco IOS XR Softwar
Fri Feb 22 15:47:12.754 CET
Cisco IOS XR Software, Version 6.2.3[Default]
RP/0/RSP0/CPU0:ASR9K-2#
02-23-2019 02:03 AM - edited 02-23-2019 02:05 AM
Hi Andreas,
How can verify or debug the traceroute process?
This bug really annoying
Regards,
Ali
02-25-2019 01:20 AM
Hello Ali,
you needed to check for Route/VRF/Interface/CEF/MPLS on how the system should process it.
Kind Regards,
Andreas
03-03-2019 02:44 AM - edited 03-03-2019 02:47 AM
At least we should see this text "Type escape sequence to abort."
Type escape sequence to abort.
Tracing the route to X.X.X.X
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide