ISE 2.7 periodic posture updates does not work

[stsag_080067084]

Hi all.

ISE version 2.7 under Work Centers>Posture>Settings>Software Updates>Posture Updates, "Automatically check for updates starting from initial delay" check box is checked with initial delay 01:00:00 every 1 Hours but no periodic updates.

I have to press on "Update Now" to get updates.

Any thoughts

Thanks in advance.

[Mohammed al Baqari]

Hi,

Just to confirm, did you have an update and it wasn't applied?

**** please remember to rate useful posts

[stsag_080067084]

Hi Mohammed,thanks for your prompt response.

If i press the "Update Now" button the update starts and completes successfully.

But if i don't, no periodic updates takes place automatically every 1 hour after the initial delay as configured.

Check attached screenshot.

Thanks in advance

 

[Mohammed al Baqari · Accepted solution]

I think you are hitting a bug and the fix is listed in 3.0. See this link
below.

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvv80113/?rfs=iqvred

***** please remember to rate useful posts