SFP compatibility matrix

[olegzeler]

http://www.cisco.com/c/en/us/td/docs/interfaces_modules/transceiver_modules/compatibility/matrix/GE_Tx_Matrix.html#_Toc487184246

say that Minimum Software Release Required for N3K-C3524P-10GX to support 1g SPF is NX-OS 6.0(3)A6(1)

But latest version available is 6.0(2). Is it typo?

[Manish Gogna]

Yes, it is a typo. Correct version is NX-OS 6.0(2)A6(1).

Manish

- Do rate helpful posts -

[olegzeler]

Thank you for the answer.

But my switch wersion is 6.0(2)A6(5a) and interface with GLC-T has status SFP validation failed

[Manish Gogna · Accepted solution]

That could be happening due to some other issue, for example 

Note

If the interface and transceiver speed is mismatched, the SFP validation failed message is displayed when you enter the show interface ethernet slot/port command. For example, if you insert a 1-Gigabit SFP transceiver into a port without configuring the speed 1000 command, you will get this error. By default, all ports are 10 Gigabits.

Manish

- Do rate helpful posts -

[olegzeler]

Thanks again. Missed it in manual.

[Fibresales9123]

Thanks for sharing. It really helps. If you guys wanna know more about fibre cables and networking than visit our website Fibresales