add ip address DNAC

[v.dumont]

When setup was run for DNAC 10gbit port was not up. no ip address was entered. 

How can I recover from this situation?

[Mike.Cifelli]

You can tweak settings after the original setup two ways:
1- Use CMIC to launch a KVM
2- Connect directly to the server
To reconfigure dnac settings you will want to use the maglev wizard:
login as maglev user:
#sudo maglev-config update

From here you can modify your NIC settings. Be aware that if you want to change your VIP I believe this requires a fresh install.

HTH!

[dhshukla]

Hi ,

Changing VIP does not require fresh install . You can use " sudo maglev-config update " to modify the VIP IP address .

Cheers

[sivathot]

Make sure no spaces when ip address is entered, Basically this issue comes up when you are setting up a cluster and you have to setup cluster VIP, if your VIP is not up the node won't be up. Hence your port wont be up.