When setup was run for DNAC 10gbit port was not up. no ip address was entered.  How can I recover from this situation?  

Hi All, is netflow supported on virtual wlc version 8.2.121.0? if so can someone point me to a config guide? I found one that states I should go to WIRELESS -> NETFLOW. I do not have a netflow entry under WIRELESS. Kind regards, Vincent Dumont

Hi All, I was wondering. I have configured dhcp for ip address allocation for my anyconnect clients. The ip address assignment but none of the other options like dns or subnetmask are passed onto the client. Is this expected behaviour? Kind regards...

Every time I send an access-accept radius message, in this message an attribute 25 is sent. I would like to remove the standard class attribute. "Class=CACS:ACS-CLA-01/151253728/39754" where ACS-CLA-01 is my hostnameplease help?