03-24-2020 12:03 PM
Hello All,
I want to run 1.3.1.4 version on my new DNAC box, But I am not sure with what version brand new box came to me.
Due to lack of infra I cannot configure all ports as of now in DNAC. In phase 1 of installation I want to do only CIMC port configuration and IOS up gradation if required.
In case of brand new DNAC box, Is there any way to check DNAC box version (software of DNAC) only after configuring CIMC IP.
I also heard that DNAC box comes with note of current running version of BOX is it true? Box is physically not accessible to me but will have to check with FE for same, So wanted to confirm before guiding him.
03-25-2020 03:25 PM
The shipped version is printed on the DNAC appliance. Also, as far as I can tell, you can't see anything useful in Maglev until you're able to SSH in to the box.
03-26-2020 02:23 AM
Thank you for confirmation Rock
03-26-2020 06:17 AM
Thank you sir, and good luck with DNA :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide