10-25-2019 03:02 AM
hello,
my question is :
what is the procedure to replace a border node in case of hardware failure?
this question since part of the configuration is manual ( ibgp between border) and another is provisionned ("lan automation, ...)
thanks
10-25-2019 05:28 AM
10-25-2019 05:43 AM
hello,
ok for the design and high availabilty but the question is :
in case of failure of a border ( hardware , RMA for the switch)
- push the saved config of the border on the new equipement
or
- discover the new equipement installed with a manual partial config and provisioning it by DNA after ?
thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide