How can i monitor DNAC appliance resource usage？

[baoyang@cisco.com]

Hi， 

I have a question about monitor DNA-C（Gen1) appliance resource usage ,etc:CPU usage、memory usage 、disk usage.

can I use SNMP or other ways to get these information？

[Dan Rowe · Accepted solution]

Hey Baoyang,

You can review this data through the CIMC GUI or CIMC CLI. You can also configure SNMP properties from the CIMC GUI in order to send traps one of your designated hosts:

-https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/sw/gui/config/guide/1-3-1/b_Cisco_UCS_C-Series_GUI_Configuration_Guide_131/Cisco_UCS_C-Series_GUI_Configuration_Guide_131_chapter10.html#task_FB71BFF36E874AB9B316FA8F49088EC4

Best Regards,

[baoyang@cisco.com]

Thanks Daniel ，its very useful！