08-29-2019 08:29 AM
Hi All,
We have just received our DNA Center appliance. Need your help to configure initial setup and next steps.
What is the latest Image I need to use?
Do I need to connect this to one of the 9300 Switch or can I connect to any management 3750 switches?
We have advantage license.
Thanks & Regards
Ravindra Tumu
08-30-2019 04:55 AM
you can start with our Cisco DNA Center Resources link https://community.cisco.com/t5/networking-documents/cisco-dna-center-resources/ta-p/3648009
This should cover getting started and also training Videos. Hope this helps.
Also you can connect to any management switch but if you are planning to add the Network devices to DNA Center then please go through the below matrix link to understand what all network devices are supported.
08-30-2019 05:33 AM
Thanks Pavan.
The link you provided has more details.
Can you help on providing the direct link to initial configuration step by step process?
Thanks
Ravindra
08-30-2019 08:35 AM
I am not sure which Appliance you are using , below is the link for M5 where you can start with installing or configuring DNA Center.
Below link have the all the other installation guides
09-03-2019 02:43 PM
An additional resource is at http://go.tklgo.cisco.com/ACC-ATX . All DNA Center and ATX Accelerators are value-add for this quarter you can sign up for a DNA Center Getting Started session. You will also have access to all past recordings from the url above.
There is also a follow-up to these lessons, to my understanding, which allows 1:1 coaching based on the attendee list, if needed.
Hope this helps sir.
09-10-2019 10:20 AM
I'm not able to view the old recordings. Can you help me on that?
Thanks
Ravindra
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide