Run Indicator Button in DNAc Applicance

[Ahmed Tarek]

hi all,

i found below guide for indicator button in DNAc appliance.

https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/2-3-5/install_guide/2ndgen/b_cisco_dna_center_install_guide_2_3_5_2ndGen.pdf

my question : is there any command to use in CLI to run this indicator button to work ? 

[Ahmed Tarek]

any help

[maflesch · Accepted solution]

Typically, this is done by pressing the button on the front panel so it lights up on the rear panel. There is a locator-led command in the CLI of the UCS chassis that will turn on a locator LED. I'm not sure if that is the same LED as the Unit Identification one you are asking about, but it is worth a shot.

https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/CLI-User-Guides/Server-Mgmt/3-1/b_Cisco_UCS_Manager_Server_Mgmt_CLI_Guide/blade_servers.html#task_2904370646248362133

It's not the same model, but the scope chassis and how to turn on the locator LED are the same.

[Ahmed Tarek]

thanks a lot for your help!