Disable automatic "Show" commands at login

[ian-heath]

Is there a way to prevent the automatic show commands at login.

"When the CLI Analyzer logs into a device for the first time, it runs a few commands automatically to detect the device type:"

[kevwilso · Accepted solution]

Hi,

If this is not a Cisco device you are logging into, you can edit the device and change the "Manufacturer" in device settings to "Non Cisco Device".

If this is a Cisco Device, you can decrease how often it runs either by device configuration or global configuration.  

• For global configuration, "Settings -> General -> Device Identification -> Recheck Time"
• For device specific config, "Edit Device -> Settings -> Device Identification Recheck Time"
• Note device settings overrides global settings

Hope this helps,

Kevin W

[ian-heath]

Ah brilliant, thanks.