cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
216
Views
0
Helpful
2
Replies
Beginner

Unable to get Max throughput with CSR

I am testing AWS TGW installing CSR in AWS VPC.

It works but ECMP is not working , I get max throughput as 1 GBps, even though I configured 4 tunnels with multipath on both sides.

Is it license problem? Please help I have see 5 year old video that does not work:

from here https://aws.amazon.com/marketplace/pp/B00EV8VXG2?ref=cns_srchrow#pdp-support

https://www.youtube.com/watch?v=ZJ8IIVCXMBs

 

Cisco IOS XE Software, Version 16.10.01b
Cisco IOS Software [Gibraltar], Virtual XE Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 16.10.1b, RELEASE SOFTWARE (fc)

License Level: ax
License Type: Default. No valid license found.
Next reload license Level: ax


Smart Licensing Status: Smart Licensing is DISABLED

cisco CSR1000V (VXE) processor (revision VXE) with 2381918K/3075K bytes of memory.
Processor board ID 9HE7Z602S3O
1 Gigabit Ethernet interface
32768K bytes of non-volatile configuration memory.
15780160K bytes of physical memory.
7774207K bytes of virtual hard disk at bootflash:.
0K bytes of WebUI ODM Files at webui:.

Configuration register is 0x2102

 

ip-10-0-0-29#show platform hardware throughput level
The current throughput level is 200000000 kb/s

 

ip-10-0-0-29(config)#license boot level appx
^
% Invalid input detected at '^' marker.

ip-10-0-0-29(config)#license boot level premium
^
% Invalid input detected at '^' marker.

 

Disappointing  I am very close but unable solve last step.

This video walks you through the steps to set up a virtual private cloud (VPC) in Amazon AWS with a Cloud Services Router CSR1000V.
2 REPLIES 2
VIP Advisor

Re: Unable to get Max throughput with CSR

Hi,

it depends on your testing. If you are using same source destination pair
with per-destination load balancing then the traffic will go over the same
link. Hence you can't cross the speed of the link

**** remember to rate useful posts
Beginner

Re: Unable to get Max throughput with CSR

Hi,

I tested with: 

Source1 to CSR to desitination1

Source2 to CSR to desitination2

Still I am getting limited to 1 GBPS throughput.

I have set multi path and see them, yet traffic goes only via one of the tunnels. I thought if it's license issue .. but maynot be. Please advise.

 

Mahesh

 

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards
This widget could not be displayed.