I am trying to use LAN automation from DNAC 184.108.40.206 and discover the devices connected to my seed and peer seed devices. The IS-IS config and other necessary part is done for seed and peer-seed but for the downlink connection to the PnP agent device(9300 switch) which has to be LAN automated, it acquires the DHCP IP from the temporary VLAN 1 DHCP pool but later is stuck into "Autoinstall trying DHCPv6 on Vlan1" this prompt. For another set of 4500-X switches, they don't go even till the DHCP. The setup is for lab demo, routing is good and the IP pool is reachable to the DNAC as I have tried testing it by assigning one of the IP to a SVI on my seed as mentioned in the LAN Auto Cisco document.
Any one faced similar issue or can someone help here!!
Thanks in advance!