cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
445
Views
15
Helpful
1
Replies

DNAC Image Repository not using Proxy

trickyg
Beginner
Beginner

I am recently upgraded to DNAC v2.2.2.6 

 

I notice now that when I try and download image via Image repository it fails and (via TCPDUMP) have determined that this is due to the fact that it is not using the configured proxy and instead is attempting to connect directly to Cisco website.

 

Proxy config is OK and proved when I check DNAC Software Upgrades this goes via Proxy and works.

 

Is anyone else experiencing this behavior. It used to work fine in previous releases

1 Reply 1

trickyg
Beginner
Beginner

Found the issue - there is a setting EULA acceptance and this was unticked after the upgrade. Ticked and now uses the proxy for Image download

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: