Adding fortigate to CML2.1

[inj-adwea]

I am trying to add fortigate VM to CML.

Got the .qcow2 file and imported the image into CML. I would like to know what the required settings to make it work?

Settings I have used:

Linux native simulation = KVM

Simulation Driver = server

Disk Driver = VirtIO

Mem = 2048

CPU = 1

Network Driver = E1000

Data and Boot Disks = 2GB

Interfaces (1 Serial and 4 physical named port1,2,3,4)

After starting the node, I cannot see anything on the console.

[balaji.bandi]

Not sure is that image is correct(is this from Fortinet site ?), here is the steps for CML to add custom image :

https://developer.cisco.com/docs/modeling-labs/#!preparing-a-custom-image

[inj-adwea]

Yes, I have downloaded the VM from fortinet support site.

FGT_VM64_KVM-v6-build1828-FORTINET.out.kvm. This contains the qcow2 file which I am using.

[balaji.bandi · Accepted solution]

Get node definition from GIT:

https://github.com/CiscoDevNet/cml-community/tree/master/node-definitions/fortinet/fortigate

reference guide :'

https://www.virtualpackets.com/adding-the-fortios-firewall-to-virl/

https://learningnetwork.cisco.com/s/article/3rd-party-vms-in-virl

[inj-adwea]

Thanks, I was able to add the Fortigate firewall using the node definition at GIT.

It is imported successfully now and I am able to access and console to it.

[leew]

Hi,

Is it also possible to use the GUI of the Fortigate too from the host browser?

Thanks for your help

[balaji.bandi]

yes if the IP exposed to your browser not inside the lab, create an another interface which has access from your LAN.