CML 2.0-Breakout Tool Error

[mwood000111]

Trying to set up the Breakout Tool. Followed installation instructions (https://developer.cisco.com/docs/modeling-labs/#!installing-breakout-tool) without any issues. The part I am getting hung up on is the configuration.  Following this here, https://developer.cisco.com/docs/modeling-labs/#!configuring-breakout-tool, at step 10, I am receiving this error:

Can't refresh data

Get xxxxxxxx.com/api/v0/keys/vnc: unsupported protocol scheme ""

Any ideas what this could be pointing to? Is this something in the config in CML or even in Cockpit that needs to be adjusted?  Ill continue to poke around though in the meantime.  Any help would be appreciated. Thanks.

[Ollie Y]

I'd hazard a guess that either configuration has an error or there is a connectivity issue from your PC to the CML server. I've not personally seen this error though.

[mwood000111]

Connectivity is there.  ICMP and tracert are successful to controller address.  Since CML/VIRL 2.0 is new, there isnt too much documentation and troubleshooting info out there. Ill try starting from scratch with this tool or moving this from a Win10 machine to a Linux box.  Thanks for the review. 

[mwood000111 · Accepted solution]

Found answer.  You have to add https:// to the URL box.  I was just using either the IP address or FQDN without https://.  Good to know.