Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We've installed the WebEx Monitoring Service from the Control Hub. Looking to add agents to our RoomKits, which register to the cloud, but we are seeing the error, "this is not an on premise device." Anyone else seeing this error or have any expe...
Trying to set up the Breakout Tool. Followed installation instructions (https://developer.cisco.com/docs/modeling-labs/#!installing-breakout-tool) without any issues. The part I am getting hung up on is the configuration. Following this here, https:...
Brief summary of issue is that sometimes when starting a meeting, whether it is scheduled or impromptu, the initial connection to the other client (usually another RoomKit in another location) experiences latency, lag in audio/video. Initial troubles...
Installed the Room 55 Dual last week and have noticed that although on the GUI its set to speed auto and same on the access layer port (C9300), interfaces are negotiating only using 100MB. Port and data sheet indicate it should be able to use full 1...
Consistently see output drops on TenGig interface (actually a 1GB fiber handoff using the TenGig SFP for MPLS) on a C9300 (16.9.1). Auto QoS applied to interface and softmax-queue is at 1200 on switch as well. Output from sh run int x/x/x, sh int x...
Connectivity is there. ICMP and tracert are successful to controller address. Since CML/VIRL 2.0 is new, there isnt too much documentation and troubleshooting info out there. Ill try starting from scratch with this tool or moving this from a Win10 ...
Thanks for the reply Mike. You are correct, these are registered to the cloud. Yes, possibility of internet traffic getting dropped outside of our network, within ISPs network is totally legit. Just want to make sure everything within our network i...
