cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
922
Views
0
Helpful
1
Replies

CML 2.2.3 - Nexus 9K Issue

jnewton83985
Level 1
Level 1

Fresh install of CML-P and was unable to boot both 9k's initially. Increased memory from 8 to 16 and processors from 4 to 6. One of the 9k's is working but the other is not. It shows 2 arrows in a circle however I am unable to stop or start it at this point. 

 

Looking at the console it shows "registration with cli server complete" however the cli is different then that of the working 9k. Its as though it is stuck mid boot. Below is my topology and what I see. 

Capture.PNG

 

I tried to boot each 9k on its own today and see the following when 9K-1 boots. 9K-2 has no issues booting at all.

 

Standalone chassis
check_bootmode: grub2pxe: grub failed, launch ipxe
Trying to load ipxe
Loading Application:
/Vendor(429bdb26-48a6-47bd-664c-801204061400)/UnknownMedia(6)/EndEntire
cannot load imageFailed to launch ipxe
Came back to grub, now load efi shell
Trying to load efishell
Loading Application:
/Vendor(429bdb26-48a6-47bd-664c-801204061400)/UnknownMedia(6)/EndEntire
cannot load imageFailed to launch shell
Trying to read config file /boot/grub/menu.lst.local from (hd0,4)
Filesystem type is ext2fs, partition type 0x83
Trying to read config file /boot/grub/menu.lst.local from (hd0,5)
Filesystem type is ext2fs, partition type 0x83
No autoboot or failed autoboot. falling to loader 

1 Accepted Solution

Accepted Solutions

jnewton83985
Level 1
Level 1

I was able to get around this issue by building a new lab.

View solution in original post

1 Reply 1

jnewton83985
Level 1
Level 1

I was able to get around this issue by building a new lab.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: