CML installation - unable to access 'user workspace management login'
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2015 09:08 AM
Hi there,
I have followed the steps detailed in 'Cisco Modeling Labs 1.0 Corporate Edition System Administrator Installation Guide' but am stuck at the point where I log into the user workspace management web page.
I have tried using both the IP address and the FQDN of the CML installation. I can ping out from the CML install. Also when I attempt to connect my HTTP session is redirected to port 8081, so I know CML is doing *something*, however I am still unable to connect.
Any help would be appreciated.
cheers,
Seb.
- Labels:
-
Cisco Modeling Labs

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2015 10:17 PM
Can you please open a TAC case so that this issue can be traced.
-Craig

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-21-2015 11:00 PM
Try Accessing with port 8000, You will be able to access AutoNetkit Visualization page.
